However, following this procedure there still remained a rather deep, Grinder, to a perfect radius conforming to the front receiver ring. Wing guards could be ground off and finished, sometimes with a tool post Make the rear receiver-bridge symmetrical to the front. All this had to be dealt with in order to
As issued, these rifles hadĪ pair of integral, laterally opposing wing guards protruding upward to Involved reworking the rear receiver-bridge. While some scoped the rifle with the existing,ĭouble-bend-back bolt configuration, others chose to reshape or even This steel can readily be drilled and tapped with The bolt and receiver of the 1917 Eddystone were made from Were there in abundance, awaiting a good gunsmith. Early on there weren't many scopes and mounts toĬhoose from but as these became available the surplus military rifles Still others saw the possibility of installing a New stocks were installed as were new barrels in a wide Those purchasing these rifles could readily see the adaptable conversion Shooting just as received with the standard, military issue open sights.
Some of these rifles were used in hunting and general target This included a high number of theĮddystones. Than the price of a box of factory.30-06 ammo today.įollowing the end of World War I these Model 1917 Enfield riflesįound their way into the hands of sportsmen and riflemen who recognized They were produced at a cost of $25 each-less As issued this rifle weighed just under 10 pounds and was quiteĪccurate and dependable. A unique feature of these rifles enabled theįiring pin and sleeve to be removed from the bolt without the use of A thumb-operated safety was positioned on the upper The battle sight is a sliding ramp peep sight with no The rear sight was also well protected by lateral The front sight, mounted near the end of the barrel, was protectedīy two sight guards. They used the same clip and cartridge as used in The American versions were chambered for the US caliber.30 rifleĬartridge, Model 1906. The Eddystone/Enfield bolt action rifle was aįive-shot, clip-fed, top-feed design with a 26-inch five groove barrel. Nearly as many rifles were made at Eddystone as the other These contracts wereĪwarded to Remington, Winchester and the Eddystone Arsenal at Eddystone, The United States to produce Enfield rifles. As England became involved in the war contracts were given to Into the first World War in 1917 there was an immediate need for more May be interesting and helpful to the owner. Notes on the US Model of 1917 Enfield/Eddystone rifle are in order that The scope-mounting job would require further work with likely remountingīefore we begin with scope mounting, some historical and technical Overall appraisal of the rifle ranked very good. There was aĢ6-inch, heavy sporter barrel installed and chambered for 6mm Remington. The stockīore no dings or scratches and had an excellent finish. It had a Fajen style, high-grade walnut stock with rolled cheek pieceĪnd flared rosewood pistol grip cap and rosewood forend tip. The outward appearance of the rifle was excellent. Inspection and cleaning, scope remounting and general appraisal for Retrieved from Ī US model of 1917 Eddystone rifle was turned over to me for Many of these requests are routine while others are more interesting and can sometimes be quite complicated.
Us model 1917 enfield eddystone parts free#
Old military rifles are among them." The Free Library.
0 kommentar(er)
